Home
Share on Facebook Share on Twitter
 Home Contact Us

Instruction Manual .pdf

iTaste MVP3.0


These mod batteries are robust but they are not indestructible, care should be taken not to drop the battery or force the eGo or 510 clearomiser fittings. It is important not to store the battery with any metal object that may cause an electrical short, this includes pocket change. It should be kept in a moderate temperature environment, avoid leaving it in a hot car for example. If the battery starts to overheat or is physically damaged it must no longer be used and should be recycled responsibly.


For operating instructions please refer to the manual supplied with the product, it is also available HERE.


The MVP3 Kit comes with a KiK ProTank 2 Clearomiser, please see the ProTank 2 help page for more information on its use and care.


 Battery Level Indicator (on the top).


Green = Almost fully charged. (When fully recharged the LED light will power off.)

Yellow = Half Power.

Red = Low Power. Charge the MVP3.0.



Technical Specifications:


Operating Voltage:    3V-9 V


Operating Wattage:   6W-30W


Standby current: 100uA max


Maximum output Wattage: 30W


Maximum output Current:10A


Maximum output Voltage: 9V


Clearomiser Resistance: 0.4 Ohm (minimum)


Battery: Built-in 3800 mAh polymer Li-Ion rechargeable battery.


Charging: Micro USB DC5V/1A


OUTPUT port :DC5V /1A



The Primary Features


Variable Voltage:

Voltage can be adjusted from 3.0 - 9.0 volts in 0.1 volt increments.


Variable Wattage:

Wattage can be adjusted from 6.0 - 30.0 Watts in 0.5 watts increments.


Low Voltage Warning:

The Red LED and Battery bar will continue blinking when the battery capacity is lower than 3.3V and it will automatically power off.


Short Circuit/Atomizer Protection:

Short Circuit/Atomizer Protection protects the MVP3.0 against shorted atomizers and will stop the unit from functioning in unsafe conditions.


Automatic real-time atomizer Ohms detection. If the resistance of the atomizer is lower than 0.4 the Ohms bar will blink and the MVP3 will not power on.


The MVP3.0 is recharged with a Micro USB cable. When plugged into a power source the iTaste MVP3.0 can also be vaped and charged at the same time.


Remembers last Voltage or Wattage setting:,When it is turned off it will remember the current voltage or wattage setting and it will retain the setting when it is powered back on.  


Portable power source for electronic products:

To charge your portable electronic device with the MVP3.0 plug the built-in Micro USB cable into the electronic device and power on the MVP3.0. The included charging cable can also be used. Plug the larger USB port into the MVP3.0 and the Micro-USB into the electronic device and power on the MVP3.0.  Do not attempt to charge more than one device at the same time or you may damage the device.  









Kik AeroTank

Instructions are supplied with your MVP3.0 we recommend that you read these and then retain them so that they may be referred to later if necessary.


When using an electronic cigarette, long slow draws are better than short sharp ones.


You should avoid covering the clearomiser air inlet hole with your fingers while inhaling.